3500 4x2 Pickup V8-360 5.9L Magnum (1994)
Fig 7 Airbag Module Remove/Install
5. Remove the four nuts attaching the airbag module to the steering wheel.
6. Remove the airbag module from the steering wheel.
7. Unplug the electrical connector from the airbag module.
8. When installing, connect the clockspring wiring connector to the module by pressing straight in on the connector. The connector should latch
securely beneath the module connector locking clip arms to assure positive connection.
9. Install the four airbag module mounting nuts and tighten to 9 to 11 Nm (80 to 100 in lb).
10. Install the speed control switch or trim bar as equipped.
11. Do not connect the battery negative cable at this time. See Airbag System Arming for proper procedure. See: Air Bag(s) Arming and
Disarming/Service and Repair
Service of Deployed Airbag Module
Any vehicle which is to be returned to use after an airbag deployment, must have both airbag modules, and the clockspring replaced. These components
will be damaged or weakened as a result of an airbag deployment, which may or may not be obvious during a visual inspection, and are not intended for
reuse.
Other vehicle components should be closely inspected. but are to be replaced only as required by the extent of the visible damage incurred.
