3500 4x2 Pickup V8-360 5.9L Magnum (1994)
8. Remove retaining ring with snap ring pliers.
9. Remove washer from the housing.
10. Remove oil seal from the housing with a seal pick.
11. Remove pitman shaft bearing from housing with a bearing driver and handle.
ASSEMBLY
1. Install pitman shaft bearing into housing with a bearing driver and handle.
2. Coat the oil seals and washer with grease.
3. Install the oil seal with a driver and handle.
4. Install backup washer.
5. Install the retainer ring with snap ring pliers.
6. Install dust seal with a driver and handle.
7. Install pitman shaft to side cover by screwing shaft in until it fully seats to side cover.
8. Install preload adjuster nut. Do not tighten nut until after Over-Center Rotation Torque adjustment has been made.
9. Install gasket to side cover and bend tabs around edges of side cover.
10. Install pitman shaft assembly and side cover to housing.
11. Install side cover bolts and tighten to 60 Nm (44 ft. lbs.).
12. Adjust Over-Center Rotation Torque.
Spool Valve
The content of this article reflects changes called for in TSB 26-01-97.
DISASSEMBLY
