3500 4x4 Pickup L6-359 5.9L DSL Turbo (1996)
Timing Pin: Service and Repair
REPLACING THE TIMING PIN
The timing pin can be replaced without removing the assembly from the gear housing.
Remove the timing pin by prying the retaining ring out with a small screwdriver. Replace the retaining ring if it is damaged during removal.
NOTE: If the timing pin assembly is removed from the gear housing, it must be precisely reset to obtain exact TDC. Refer to the Timing Pin
Housing Assembly - Installation (With Head On) in this section of the manual.
Install a new 0-ring, lubricate the pin and position in the housing. Install the new retaining ring.
A = 1.5mm [0.059 inch]
Torque Value: 5 N-m [44 in-lbs]
TIMING PIN ASSEMBLY OR GASKET - REPLACEMENT
Locate TDC for Cylinder No.1.