3500 4x4 Pickup L6-359 5.9L DSL Turbo (1996)
necessary (temporary rough engine running may occur). If necessary, refer to the Air Bleed Procedure for procedures. See: Powertrain
Management/Fuel Delivery and Air Induction/Adjustments
3. Fill filter/separator with clean fuel.
4. Apply a light film of clean unused engine oil to the filter/separator seal.
Fuel/Water Separator O-Ring
5. Install a new 0-ring seal to the filter/separator housing.
6. Install filter/separator to housing. Tighten filter/separator one-half turn after it makes contact with the housing. Tighten by hand only.
7. Connect electrical connector to WIF sensor.
8. Connect drain hose to drain valve.
