3500 4x4 Pickup L6-359 5.9L DSL Turbo (1996)
ASSEMBLE
1. Press sleeve into housing using a suitable socket and press.
2. Install dowel pin, seal and pressure plate spring.
3. Install O-ring seal, pressure plate and dowel pins. Mark top of pressure plate where pin enters from underneath to ease alignment with dowel pin
during assembly.
4. Lubricate O-ring, pump ring, rotor and vanes with power steering fluid. Install vanes and rotor with rounded edge facing away from rotor. Ensure
counterbore of rotor faces driveshaft end of housing.
5. Install pump ring with identification marks facing up, then install O-ring seal and thrust plate. Thrust plate dimples must line up with bolt holes in
housing and plate must engage pump ring dowel pins.