3500 4x4 Pickup V10-488 8.0L Magnum (1994)
Ignition Cable: Service and Repair
Cable Removal
CAUTION: When disconnecting a high voltage cable from a spark plug or ignition coil, twist the rubber boot slightly (1/2 turn) to break it loose. Grasp
the boot (not the cable) and pull it off with a steady, even force.
Firing Order V10
When replacing the spark plug and coil cables, route the cables correctly and secure in the proper retainers. Failure to route the cables properly can cause
the radio to reproduce ignition noise. It could also cause cross ignition of the plugs, or short circuit the cables to ground. When installing new cables,
make sure a positive connection is made. A snap should be felt when a good connection is made between the plug cable and the distributor cap tower.
