400 L4-156 2.6L (1982)
4.
Remove the existing hose clip on the valve cover and discard.
5.
Attach the 7" long hose on the reservoir inlet to the fuel pump outlet nipple and clamp with hose clump, PN 6500650 (Figure 4). Torque to 10
inch pounds.
FIGURE 5 - SPEED SENSOR RELOCATION
6.
Vehicles equipped with a speed sensor on the right shock tower or right fender shield may have to have it relocated to allow room for
pressure regulator.
To relocate sensor, mark and drill 1/8" hole for upper sensor mount on right fender shield (Figure 5). Reattach sensor with upper screw.
Adjust the speed sensor to a 30~ angle as shown, center punch, and drill 1/8" hole for the second attaching screw. Install the second screw
and tighten both screws securely.
