400 L4-156 2.6L (1982)
d.
Fuel reservoir-to-pressure regulator inlet hose.
Close the top part of the clip over the hoses, attach clip with original hose clip screw, and tighten securely.
E.
Underbody Component Installation
1.
Remove existing fuel tank and install the new fuel tank assembly, PN 4203719, following the service manual procedure. Use a
new positioning pad, PN 4185506, and new insulator pads, PN 4185395 and 4279340. Use the new fuel tank straps, PN 4279175
and 4279174. Be sure to attach the fuel tank vent hose to the fuel tank before it is raised against the floor pan. Use new fuel supply
hose, PN 4279877, and new fuel return hose, PN 4279874.
2.
Connect the 5-pin terminal of the body wiring harness to the fuel tank gauge unit.
3.
Reconnect the battery.
4.
Check the pressure regulator, fuel reservoir, and hose clip for secure mounting. Check all fuel hoses for proper routing, making
sure they are not contacting any sharp metal edges. Insure clamps are tight and make sure no sharp edges or clamp screws are
contacting adjacent hoses or wires. Inspect entire installation for proper wire routing.
5.
Start the engine and check the entire system for fuel leaks.
FIGURE 9
6.
Type in Authorized Modification Label, PN 4275086, as shown in Figure 9 and attach near VECI label.
F.
After-Run Fan (if applicable)
1.
Disconnect the 2-way plug for the ambient air sensor that is located on the fan motor brace.
2.
Tie wrap both ends of the harness back to assure the leads will not be caught in the fan.
POLICY:
Reimbursable within the provisions of the warranty
TIME ALLOWANCE:
14-70-11-96 2.9 Hrs. Labor Operation No.
FAILURE CODE:
AM - Authorized Modification
Parts List Vapor Lock Package
1981-1982 K PASSENGER CARS 2.6L ENGINE
PART NUMBER 4411991
QTY.
NAME
PART NO.
1
Control Module
5226640
11
Tie Wrap
6015756
1
Jumper Harness
4209344
