400 L4-156 2.6L (1982)
Remove inlet nipple of fuel flow sensor and discard. Install new 30~ inlet nipple, PN 4307236, with nipple pointing to driver's side of car and
slightly downward (Figure 7).
Remove the fuel filter-to-fuel pump hose at the fuel filter and slide convolute sleeve, PN 4279993, over the fuel hose. Reattach the hose to the
fuel filter using the original hose clamp.
Connect hose assembly, PN 4307763, from the pressure regulator outlet (upper fitting) to the fuel flow sensor inlet nipple, routing the hose as
shown in Figure
7.
When installing hose clamp, PN 6500650, at the flow sensor, locate the clamp screw and tangs on the lower side of the hose so no sharp
metal edges contact the fuel filter-to-fuel pump hose. Torque to 10 inch pounds.
