Avenger L4-2.0L DOHC (1995)
Tool 6906 (follow the instructions provided with the tool).
7.
Using the procedures outlined in the appropriate Service Manual, re-assemble and install the transaxle into vehicle then adjust the transaxle fluid
level.
8.
Check for and erase any Transmission Control Module (TCM) DTC'S using the MDS or DRB III before proceeding with the quick learn
procedure.
NOTE:
FAILURE TO PERFORM THE QUICK LEARN PROCEDURE CAN RESULT IN A LOW MILEAGE TRANSAXLE FAILURE OR POOR
INITIAL SHIFT QUALITY.
9.
Perform the quick learn procedure for the TCM:
A.
Ensure the transmission fluid level is correct.
B.
Start vehicle, place the shift lever in Overdrive (OD), move the vehicle at least five feet with the engine running and then place shifter in
Neutral (N). Apply the parking brake and let the engine idle. This purges the air in the clutch circuits to prevent erroneous clutch volume
values which could cause poor initial shift quality or a low mileage transaxle failure.
C.
Using the DRB III select the 1994 - 1997 Diagnostics option (1) and choose Transmissions.
D.
Choose the Trans Overhauled/Replaced option and follow the instructions on the DRB III screen.
E.
After performing quick learn read Powertrain Control Module (PCM) and TCM DTC'S. If only DTC 12 exists, erase the DTC. If there are
other DTC'S, perform the proper diagnostics for those DTC'S.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
**21-00-05-92** AA, AJ, AS, ES
7.1 Hrs.
LH
8.9 Hrs.
FJ
8.2 Hrs.
JA
9.3 Hrs.
JX
9.3 Hrs.
NS, GS
7.6 Hrs.
Related Operation:
21-34-41-58
Trans Cooler Reverse Flush & Flow
Check - Miller Tool 6906
0.4 Hrs.
Optional Equipment:
21-00-05-64
AS with All Wheel Drive
1.2 Hrs.
21-00-05-63
AS with Antilock Brakes
0.2 Hrs.
FAILURE CODE:
SD - Shudder
