dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Spark Plugs - Intermittent Misfire|Page 5857 > < Ignition System - Engine Misfire
Page 1
background image

Spark Plug: All Technical Service Bulletins
Spark Plugs - Intermittent Misfire

NO: 18-10-97

GROUP: Vehicle Performance

DATE: Feb. 28, 1997

SUBJECT: 
Intermittent Single Cylinder Misfire And/Or MIL Illuminated

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 18-15-96 REV. A DATED JULY 12, 1996 WHICH SHOULD BE
REMOVED FROM YOUR FILES AND MARKED IN THE 1996 TECHNICAL SERVICE BULLETIN BOOK (PUBLICATION NO. 81-699-97010).
ALL CHANGES ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE SPECIFIC ENGINE APPLICATIONS FOR FJ MODELS.

MODELS:

1995 - 1996 (PL)

Neon

1995 - 1996 (FJ)

Avenger/Sebring/Talon

1995 - 1996 (JA)

Cirrus/Stratus

NOTE: 

THIS BULLETIN APPLIES TO VEHICLES BUILT WITH 2.0L SOHC ENGINE (JA & PL), PRIOR TO JANUARY 2, 1996 (MDH 01-02-XX)
AND WITH 2.0L DOHC ENGINE (PL) PRIOR TO APRIL 1, 1996 (MDH 04-01-XX) AND TO ALL 1995 & 1996 FJ **NATURALLY
ASPIRATED** 2.0L VEHICLES.

SYMPTOM/CONDITION:

Intermittent single cylinder misfire as indicated by the Diagnostic Trouble Code (DTC) screen on the DRB III which cannot be readily reproduced.

DIAGNOSIS:

Follow the diagnostic steps in the 1996 Powertrain Diagnostic Manual for 2.0L/2.4L/2.5L/3.3L/3.5L Electronic Fuel Injection (Publication Number
81-699-95008), pages 417 to 419 (Test 107A). If the diagnostic repair procedure does not repair the problem, proceed to the repair procedure.

PARTS REQUIRED:

NOTE: 

IT IS IMPERATIVE THAT THE CHRYSLER PART NUMBER GIVEN BELOW BE REQUESTED WHEN ORDERING. ONLY THE
CHRYSLER PART NUMBER WAS CHANGED, THE CHAMPION PART NUMBER DID NOT CHANGE.

AR

5269897

Spark Plug, (PL & JA - SOHC & DOHC)

AR

5269899

Spark Plug, (FJ- DOHC **Naturally Aspirated**)

REPAIR PROCEDURE:

This bulletin involves the replacement of the spark plug in the effected cylinder with a new spark plug.

1.

Remove the spark plug cable.

2.

Remove the spark plug and discard.

3.

Install the new spark plug and torque to 28 Nm (20 ft. lbs.).

4.

Install the spark plug cable.

NOTE: 

THE FOLLOWING STEP IS REQUIRED BY LAW.

Spark Plugs - Intermittent Misfire|Page 5857 > < Ignition System - Engine Misfire