Avenger L4-2.0L DOHC (1995)
Transmission Speed Sensor: All Technical Service Bulletins
A/T - Transaxle Limp In Condition
NO: 21-10-95
GROUP: Transmission
DATE: Jun. 30, 1995
SUBJECT:
Transaxle Limp-In Condition - Intermittent Input (Turbine) Speed Sensor Signal
MODELS:
1995
(AA) Spirit/Acclaim/LeBaron Sedan
1995
(AJ) LeBaron Convertible
1995
(AS) Town & Country/Caravan/Voyager
1995
(ES) Chrysler Voyager (European Market)
1995
(FJ) Sebring/Avenger/Talon
1995
(JA) Cirrus/Stratus
1995
(LH) Concorde/LHS/New Yorker/Intrepid/Vision
1996
(NS) Town & Country/Caravan/Voyager
NOTE:
THIS BULLETIN APPLIES TO VEHICLES BUILT BETWEEN DEC. 1, 1994 (MDH 1201 XX) AND APR. 30, 1995 (MDH 0430XX) AND
EQUIPPED WITH A 41TE OR 42LE TRANSAXLE WITH A DATE CODE BETWEEN 2183 AND 2295 (REFER TO ILLUSTRATION).
SYMPTOM/CONDITION:
Transaxle in limp-in condition due to intermittent transaxle input speed sensor signal.
DIAGNOSIS:
Using the Mopar Diagnostic System (MDS) or the Scan Tool (DRB III) with the appropriate Diagnostic Procedure Manual, verify all
engine/transmission systems are functioning as designed. Test drive the vehicle throughout the transaxle operating temperature range. With the DRB III
in the RPM Display Mode under Transmission Systems, monitor the Input (Turbine) Speed Sensor Signal. If the Input (Turbine) Speed Sensor Signal
drops to 0 RPM and is accompanied by any of the following Diagnostic Trouble Codes (DTC's) 36, 50, 51, 52, 53, 54, 55, or 56 perform the Repair
Procedure of this bulletin.
PARTS REQUIRED:
1.
4412878 Sensor, Input (Turbine) Speed
REPAIR PROCEDURE:
This bulletin involves replacing the input (turbine) speed sensor with an improved part.
1.
Disconnect the input (turbine) speed sensor wiring connector, be sure the weather seal does not fall off or remain in the sensor that is being
replaced.
2.
Remove the input (turbine) speed sensor.
