Avenger L4-2.4L (2009)
10. Reach up behind the left side of the center stack and disconnect the ignition switch electrical connector (6) and the WCM electrical connector (5).
11. Insert the ignition key into the ignition cylinder. Push the shift interlock cable locking tab inward and rotate the ignition key to the on position.
This will release the cable from the ignition switch. Remove the shift interlock cable from the ignition cylinder.
12. Remove the ignition switch support bracket screw (1).
13. Remove the two ignition switch mounting screws (1) and remove one upper screw from the ignition cylinder support bracket. It will be necessary
to detach the left side of the center instrument panel trim to gain access to one of the ignition switch mounting screws.
14. Disconnect the WCM antenna from the WCM receiver.
