Avenger L4-2.4L (2009)
Alarm Module: Service and Repair
Sentry Key Immobilizer Module (SKREEM) - Installation
INSTALLATION
SEBRING
NOTE: After a SKREEM/WCM is replaced, the ignition/transponder keys need to be programmed to the new SKREEM/WCM. Follow the
directions on the diagnostic scan tool. The transponder key for the SKREES/SKIM and the RKE will both be programmed during
this operation. There is no need to program the fob of the key for RKE functionality once the transponder key is programmed to the
new SKREEM/WCM.
NOTE: When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order:
NOTE: The WIN/SKREEM/WCM initialization procedure is required whenever the WIN/SKREEM/WCM or shaft lock module is replaced
on vehicles equipped with the shaft lock module.See: Service and Repair
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Program all ignition/transponder keys to the new SKREEM/WCM.
See: Keyless Entry/Keyless Entry Module/Testing and Inspection.
1. Position the WCM on the ignition lock housing make sure the locking tabs are engaged into the ignition switch then install the retaining screw (1)
.
2. Position the ignition switch/cylinder assembly up in behind the instrument panel.