Avenger L4-2.4L (2009)
Sunroof / Moonroof Motor: Service and Repair
Sunroof Motor - Installation
INSTALLATION
1. If sunroof was open when drive motor was removed, carefully move glass panel into closed position and remove glass panel. See: Sunroof /
Moonroof Panel/Service and Repair/Sunroof Glass - Removal
2. Set lifter arm timing by manually sliding the mechanisms (1) in the track until timing holes in the trollies are aligned with the timing holes in the
lifter arm cams (2) and insert pins (3) into the mechanisms to hold mechanisms in closed position.
3. Place motor (3) into position and install screws (4) attaching motor to bracket (2).
4. Tighten the screws (4) to 3 Nm (26 in. lbs.).
5. If sunroof glass panel was removed previously, remove the timing pins and install the sunroof glass panel. See: Sunroof / Moonroof Panel/Service
and Repair/Sunroof Glass - Installation
6. Partially install the headliner and connect the sunroof wiring electrical connectors. See: Interior Moulding / Trim/Headliner/Service and
Repair/Headliner - Installation
7. Temporarily install sunroof switch and perform the sunroof motor teach procedure. See: Testing and Inspection.
8. Test sunroof operation, adjust glass as necessary. See: Sunroof / Moonroof Panel/Adjustments
9. Complete the headliner installation. See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Installation