Avenger L4-2.4L (2009)
9. Loosen, but do not remove, the two mounting screws (2) attaching the ICU (1) mounting bracket to the body.
10. Lift the ICU and mounting bracket (1) off the mounting screws (2).
11. Move the brake tubes around as necessary without bending them and remove the ICU with bracket through the opening between the A/C lines and
the exhaust manifold.
12. To separate the ABM from the HCU, See: Overhaul/Integrated Control Unit (ICU) - Disassembly.
Integrated Control Unit (ICU) - Installation
2.0L/2.4L ENGINE
1. Install the ICU with bracket (1) through the opening between the A/C lines and the exhaust manifold using the opposite of how it was removed.
2. Place the mounting bracket for the ICU (1) over the mounting screws (2) and hang the assembly in place. Tighten the two mounting screws (2) to
23 Nm (17 ft. lbs.).
CAUTION: Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.
3. Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.
