Avenger L4-2.4L (2009)
Heater Core: Service and Repair
Installation
INSTALLATION
NOTE: LHD model with A/C shown. RHD and heater-only models similar.
1. Carefully install the heater core (5) into the side of the air distribution housing (4).
2. On RHD models, install the air distribution housing onto the HVAC housing (7) See: Heating and Air Conditioning/Housing Assembly
HVAC/Service and Repair/Removal and Replacement/HVAC Housing - Installation.
3. Install the heater core tube brackets (6) and retaining screws (3). Tighten the screws to 1.2 Nm (10 in. lbs.)
4. Install the flange (2) that secures the heater core tubes to the front of the HVAC housing.
5. Install the screw (80) that secures the flange to the HVAC housing. Tighten the screw to 1.2 Nm (10 in. lbs.).
NOTE: If the foam seal for the flange is deformed or damaged, it must be replaced.
6. Install the foam seal (1) onto the flange.
7. Install the left side front floor duct See: Heating and Air Conditioning/Air Duct/Service and Repair/Floor Distribution Duct - Installation.
NOTE: If the heater core is being replaced, flush the cooling system See: Service and Repair .
8. Install the HVAC housing assembly See: Heating and Air Conditioning/Housing Assembly HVAC/Service and Repair/Removal and
Replacement/HVAC Housing - Installation.
