Avenger L4-2.4L (2009)
1. Throughly clean all gasket mating surfaces before assembling.
2. Inspect water pump and components for any damage.See: Procedures/Water Pump - Inspection
3. Using bolts (3), install the water pump (4) and gasket (8) to the water pump adapter (6). Tighten the bolts (3) to 22 N-m (16 lbs. ft.)
4. Using bolts (1), install the water pump pulley (2) to the water pump (4). Tighten the bolts (1) to 9 N-m (80 lbs. in.)
5. Using bolts (5), install the water pump assembly and gasket to the engine block. Tighten the bolts to 24 Nm (18 lbs. ft.).See: Water Pump -
Installation
6. Start the engine and check for leaks.See: Cooling System/Testing and Inspection/Component Tests and General Diagnostics
Water Pump - Installation
2.0/2.4L ENGINE
