Avenger L4-2.4L (2009)
1. Position the water pump assembly (3) into the water pump housing (4).
2. Install the mounting bolts (2). Tighten the bolts to 24 Nm (18 ft. lbs.).
3. Install the water pump pulley (1). Tighten the bolts to 9 Nm (80 in lbs.).
4. Install the drive belt splash shield.
5. Lower the vehicle.
6. Install the accessory drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Installation.
7. Connect the negative battery terminal.
8. Evacuate air and refill cooling system. See: Procedures/Water Pump - Coolant Air Evacuation
9. Check cooling system for leaks.See: Cooling System/Service and Repair
