Avenger L4-2.4L (2009)
1. Position the A/C liquid and suction line assembly (4) into the engine compartment.
2. Remove the tape or plugs from the refrigerant line fittings and the evaporator ports.
3. Lubricate the rubber O-rings on new dual-plane seals with clean refrigerant oil and install the seals onto the liquid and suction line fittings. Use
only the specified seals as they are made of special materials compatible to the R-134a system. Use only refrigerant oil of the type recommended
for the A/C compressor in the vehicle.
4. Connect the A/C liquid and suction line assembly to the A/C evaporator (6).
5. Install the bolt (3) that secures the A/C liquid and suction line assembly to the A/C evaporator. Tighten the bolt to 25 Nm (18 ft. lbs.).
6. On RHD models, engage the retainers that secure the power brake booster vacuum supply hose to the dash panel.
7. Install the nut (1) that secures the refrigerant line bracket (2) to the right front strut tower (5). Tighten the nut to 20 Nm (15 ft. lbs.).
8. Install the power steering fluid reservoir and the engine coolant reservoir.
9. Position the heat shield (3) onto the three studs (1) located on the dash panel in the engine compartment.
10. Install the three nuts (2) that secure the heat shield to the dash panel. Tighten the nuts to 1 Nm (10 in. lbs.).
