Avenger L4-2.4L (2009)
6. Using needle nose pliers (1), disengage the two retaining tabs (2) that secure the evaporator temperature sensor (3) to the driver side of the HVAC
housing (4) and remove the sensor.
NOTE: If the foam seal for the flange is deformed or damaged, it must be replaced.
7. Carefully remove the foam seal (2) from the front of the two halves of the HVAC housing (4). If the seal is deformed or damaged, it must be
replaced.
8. Remove the nine screws (3) and three metal clips (5) that secure the two halves of the HVAC housing together.
9. Disengage the nine plastic retaining tabs (1) that secure the two halves of the HVAC housing together and separate the housing.
NOTE: If the foam insulator around the A/C evaporator is deformed or damaged, the insulator must be replaced.
10. Carefully lift the A/C evaporator (1) and the foam insulator (2) out of the lower half of the HVAC housing (3).
NOTE: If the seal around the evaporator tube tapping block is deformed or damaged, the seal must be replaced.
