Avenger L4-2.4L (2009)
Information Bus: Diagram Information and Instructions
Warnings
WARNINGS - GENERAL
WARNINGSprovide information to prevent personal injury and vehicle damage. Below is a list of general warnings that should be followed any time a
vehicle is being serviced.
WARNING: Always wear safety glasses for eye protection.
WARNING: Use safety stands anytime a procedure requires being under a vehicle.
WARNING: Be sure that the ignition switch always is in the off position, unless the procedure requires it to be on.
WARNING: Set the parking brake when working on any vehicle. An automatic transmission should be in park. A manual transmission should
be in neutral.
WARNING: Operate the engine only in a well-ventilated area.
WARNING: Keep away from moving parts when the engine is running, especially the fan and belts.
WARNING: To prevent serious burns, avoid contact with hot parts such as the radiator, exhaust manifold(s), tail pipe, catalytic converter and
muffler.
WARNING: Do not allow flame or sparks near the battery. Gases are always present in and around the battery.
WARNING: Always remove rings, watches, loose hanging jewelry and avoid loose clothing.
Warnings Hybrid Electric Vehicles (HEV)
WARNINGS - HYBRID ELECTRIC VEHICLES (HEV)
Hybrid Electric Vehicles are equipped with a high voltage components and wiring. Each high voltage component is labeled with the high voltage
symbol. High voltage cables are orange in color or protected by metal conduit.
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety Procedures.
These procedures are located in the Service tab, section 08-Electrical. In addition, before performing any diagnostic or service
procedure near a high voltage component, you must perform the High Voltage Power Down procedure located in the Service Tab,
08-Electrical/8 - Engine Systems/Battery System - Standard Procedure. Failure to follow these instructions may result in possible
serious or fatal injury.
How to Use Wiring Diagrams
HOW TO USE WIRING DIAGRAMS
Chrysler Corporation wiring diagrams are designed to provide information regarding the vehicles wiring content. In order to effectively use the wiring
diagrams to diagnose and repair Chrysler Corporation vehicles, it is important to understand all of their features and characteristics.
Diagrams are arranged such that the power (B+) side of the circuit is placed near the top of the page, and the ground (B-) side of the circuit is placed
near the bottom of the page.
All switches, components, and modules are shown in the at rest position with the doors closed and the key removed from the ignition.
Components are shown two ways. A solid line around a component indicates that the component is complete. A dashed line around the component
indicates that the component is being shown is not complete. Incomplete components have a reference number to indicate the page where the component
is shown complete.
It is important to realize that no attempt is made on the diagrams to represent components and wiring as they appear on the vehicle. For example, a short
piece of wire is treated the same as a long one. In addition, switches and other components are shown as simply as possible, with regard to function only.
