Avenger L4-2.4L (2009)
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may
result in serious or fatal injury.
3. From behind the steering wheel (2), gently pry off the driver airbag bolt covers.
4. Remove the two driver airbag attaching bolts (4).
5. Pull airbag rearward and disconnect the two airbag squib connectors (1).
6. Remove airbag (3) from vehicle.
WARNING: When replacing a deployed driver airbag, the clockspring MUST also be replaced See: Accessories and Optional Equipment/Steering
Mounted Controls Communication Module/Service and Repair/Steering Column Control Module - Removal .
Driver Air Bag - Installation
AIRBAG
1. Connect the squib connectors (1) to the driver airbag (3).
2. Position the driver airbag (3) in the steering wheel (2) and push forward.
WARNING: Make sure not to pinch any wires underneath the driver airbag.
