Avenger L4-2.4L (2009)
Remote Switch: Description and Operation
Remote Radio Switches - Operation
OPERATION
The six switches in the two remote radio switch units are normally open, resistor multiplexed momentary switches that are hard wired to the Totally
Integrated Power Module (TIPM) through the clockspring. The TIPM sends a five volt reference signal to both switch units on one circuit, and senses
the status of all of the switches by reading the voltage drop on a second circuit.
When the TIPM senses an input (voltage drop) from any one of the remote radio switches, it sends the proper switch status messages on the Controller
Area Network (CAN) data bus network to the radio receiver. The electronic circuitry within the radio receiver is programmed to respond to these remote
radio switch status messages by adjusting the radio settings as requested. For diagnosis of the TIPM or the CAN data bus, the use of a scan tool and the
proper Diagnostic Procedures information is recommended.
