Avenger L4-2.4L (2009)
4. If not already together, install the upper spring isolator (10) on the upper mounting bracket (4). Make sure the tab on the isolator is positioned
toward the forward mounting stud on the mounting bracket (See above note).
5. Install the upper mounting bracket (4) on top of the coil spring (11) matching the step in the isolator to the end of the coil.
6. Install the lower spring isolator (12) on the spring seat of the shock absorber (13).
7. Slide the dust shield (9), jounce bumper (8) and washer (7) onto the shock rod.
8. Install the shock absorber (13) up through the bottom of the coil spring (11) and upper mounting bracket until the lower spring seat contacts the
lower end of the coil spring.
9. While holding the shock absorber in position, install the washer (2) and nut (1) on the end of the shock rod.
CAUTION: Never use impact or high speed tools to remove the shock rod nut. Damage to the shock internal bearings can occur.
