Avenger V6-2.5L VIN N (1998)
REPLACEMENT
Only the case that a dust cover is damaged by mistake during servicing, replace it as follows:
1. Remove the dust cover.
2. Apply Mopar (R) Multi-mileage Lubricant Part No. 2525035 or equivalent.
3. Apply specified grease to the shown portion on the top of the lateral lower arm assembly dust cover.
CAUTION: Be careful not to let specified grease touch the ball joint thread and the knuckle joint (tapered portion). If it touchers, wipe it
away.
4. Drive in the dust cover with special tool until it is fully seated.
5. Check the dust cover for cracks or damage by pushing it with finger.
Rear
NOTE: The only reason to replace the dust cover is if it is damaged by mistake during servicing, replace it as follows.
DUST COVER REPLACEMENT
1. Remove the dust cover.
2. Apply multipurpose grease to the lip and inside of the dust cover. Mopar (R) Multi-mileage Lubricant Part No. 2525035 or equivalent
3. Drive in the dust cover with the special tool until it is fully seated.