Avenger V6-2.7L (2008)
>
If the vehicle has a clear plastic hose and hose clamp perform the following procedure:
a.
Slide the hose clamp off of the release handle cable bezel.
b.
Slide the clear plastic hose off of the release handle cable bezel.
c.
Disconnect the cable end from the interior door release handle arm.
d.
Remove the cable from the interior door release handle cable bezel.
e.
Remove and discard the hose clamp and clear plastic hose from the cable.
f.
Insert the cable into the interior door release handle cable bezel.
g.
Attach the cable end to the interior door release handle arm.
h.
Continue with Step 9 of this procedure
9.
Install one interior door latch cable retaining clip as shown in Figure 3.
