Avenger V6-2.7L (2008)
4. Install the stabilizer bar and bolts to the rear suspension crossmember and tighten to 24.5 Nm (18 ft. lbs.).
5. Install the wheel speed sensor bracket and tighten the bolt to 18 Nm (13 ft. lbs.).
6. Remove the strong cord or wire used to support the knuckle and install the lower control arm See: Steering and Suspension/Suspension/Control
Arm/Service and Repair/Rear Lower Control Arm - Installation.
7. Install the upper control arm to the rear suspension crossmember and tighten all bolts to 108.5 Nm (80 ft. lbs.).
