Avenger V6-2.7L (2008)
4. Move seat belt adjuster all the way down exposing the B-pillar screw. Remove B-pillar screw.
5. Using trim stick C-4755, pry up B-pillar and route seat belt through B-pillar trim. Remove B-pillar bottom (2) first and remove trim from B-pillar.
Installation
INSTALLATION
1. Insert top of B-pillar trim locator (1) into position.
2. Before hinging B-pillar upward into place, route seat belt anchor (3) through seat belt adjuster opening.
3. Fasten seat belt anchor (3) to seat.See: Restraint Systems/Seat Belt Systems/Seat Belt Height Adjuster/Service and Repair/Installation
4. Hinge B-pillar trim (2) downward, engaging clips ensuring proper seat.
5. Install B-pillar screw into B-pillar.
6. Snap SRS airbag anchor cover into place ensuring proper seat.
Removal
REMOVAL
1. Remove seat belt anchor bolt.See: Restraint Systems/Seat Belt Systems/Seat Belt Retractor/Service and Repair/Rear Seat Belt Retractor - Removal
2. Using trim stick C-4755, pry the rear of panel forward disengaging clip (3).
3. Using a flat blade screwdriver or equivalent, push down on tab (2) disengaging tab. Slide tether out of tether housing (1).
