Avenger V6-2.7L (2008)
REMOVAL
1. Remove the quarter trim panel. See: Lower Quarter Trim Panel/Lower Quarter Trim - Removal.
2. Inspect the welds (1) that attach the inner reinforcement (2) to the quarter trim at the upper outboard edge. If any of the welds are broken, replace
the quarter trim panel.
3. Remove the 4 screws that attach the flipper door assembly to the inner reinforcement.
Installation
INSTALLATION
1. Insert the new flipper door assembly into the panel and install the 4 screws loosely to allow alignment/adjustment.
2. Lay the panel on its side and align the door to the trim panel.
3. Tighten the screws in the following order: forward fastener (1), rear inboard fastener (2), rear outboard fastener (3), then mid fastener (4).
