Avenger V6-2.7L (2008)
NOTE: Fabric covered cushions are serviced as an assembly.
1. Pull upward at forward edge of cushion (3) each retainer loop of the rear seat cushion to disengage retainer loops from cups in floor (2).
2. Guide seat belts through loops.
3. Remove rear seat cushion from vehicle.
Front
INSTALLATION
1. Set seat cushion pan into place.
2. Install wire harness fasteners to cushion frame.
3. Install seat pan cushion fasteners (1). Tighten to 11 Nm (8 ft.lbs.)
4. Connect switch wire connectors (2, 3, and 4) to the cushion side shield, if equipped.
5. Install seat back.See: Seat Back/Service and Repair/Seat Back - Installation
6. Install cushion side shields.See: Seat Cushion Side Shields - Installation
7. Install seat in vehicle.See: Service and Repair/Seat - Installation
Rear
INSTALLATION
