Avenger V6-2.7L (2008)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: The heated seat switches are integral to the Accessory Switch Bank Module (ASBM) and cannot be serviced separately. The complete
ASBM assembly must be replaced.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel from the instrument panel, See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Center Bezel - Removal.
3. Remove the four screws (1) that secure the ASBM (2) to the back of the instrument panel center bezel (3) and remove the ASBM.
