Avenger V6-2.7L (2008)
Lateral Accelerometer: Service and Repair
Installation
INSTALLATION
1. Install the dynamics sensor (1) over the studs mounted to the floor pan tunnel (4).
2. Install the two mounting nuts (2). Tighten the nuts to 9 Nm (80 in. lbs.).
3. Connect the wiring harness connector (3) to the dynamics sensor (1).
4. Install the center console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center Console - Installation
5. Connect the battery negative cable to the battery post. It is important that this be performed properly. See: Starting and Charging/Battery/Service
and Repair/Procedures/Battery Reconnection
6. Perform the Verification Test and clear any faults. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests
