Avenger V6-2.7L (2008)
Brake Pedal Assy: Service and Repair
Installation
BRAKE PEDAL
1. Carefully install the brake pedal and bracket assembly (1) in the vehicle lining up the bracket with the power brake booster mounting studs and the
stud (2) on the dash panel.
2. Install the four nuts (4) attaching the brake pedal (1) (and power brake booster) to the dash panel. Do not tighten the nuts at this time.
3. Install the remaining nut (5) attaching the brake pedal (1) to the dash panel. To tighten this nut (and the other four from the preceding step), refer
to the following step.
CAUTION: Because of power brake booster design, it is very important to tighten the mounting nuts in the proper sequence.
4. Tighten the brake pedal/booster mounting nuts in the proper sequence to 23 Nm (17 ft. lbs.).
