Avenger V6-2.7L (2008)
4. Unthread the brake tube nut (2) at the rear flex hose.
5. Remove the clip (3) securing the rear flex hose to the trailing link mounted bracket. Remove the flex hose from the bracket.
6. Unthread and remove the brake flex hose (4) from the brake caliper (1).
CAUTION: When removing the caliper guide pin bolts (2, 3) note that one has a special sleeve on the end. It is important that this bolt (3) be
installed in the upper mounting hole when the caliper is installed.
7. Remove the two brake caliper guide pin bolts (2, 3).
8. Slide and remove the disc brake caliper (1) with outboard brake pad attached from the disc brake adapter bracket, inboard brake pad and rotor.
9. Remove the outboard brake pad from the caliper by prying the brake pad retaining clip over the raised area on the caliper. Slide the brake pad off
of the brake caliper.
Front
INSTALLATION
1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston
before installing the C-clamp to avoid damaging the piston.
