Avenger V6-2.7L (2008)
INSTALLATION
NOTE: Perform STEP 1 through STEP 6 on each side of the vehicle to complete pad set installation, then proceed to STEP 7.
1. Completely retract the caliper piston back into the piston bore of the caliper. This is required to gain the necessary pad-to-rotor clearance for the
caliper installation onto the steering knuckle.
NOTE: Place the brake pad with the audible wear indicator attached on the inboard side. The audible wear indicator should be positioned at
the bottom when installed.
2. Slide the outboard brake pad (2) onto the caliper (1). Be sure the retaining clip is squarely seated in the depressed areas on the caliper beyond the
raised retaining bead.
3. Place the inboard brake pad (5) in the abutment shims (4) clipped into the disc brake caliper adapter bracket (3) as shown (see preceding note).
CAUTION: Use care when installing the caliper onto the adapter bracket to avoid damaging the guide pin boot.
4. Rotate the disc brake caliper downward over the brake rotor and lower part of caliper adapter.
5. Install the disc brake caliper (2) lower guide pin bolt (1). Tighten the guide pin bolt to 43 Nm (32 ft. lbs.).
