Avenger V6-2.7L (2008)
Backing Plate: Service and Repair
Installation
INSTALLATION
1. Assemble the hub and bearing (3) through the support plate (2) and install the spacer (1) on the rear of the assembly.
2. Install the hub and bearing (3), support plate (2), and spacer (1) as an assembly on the knuckle.
NOTE: When performing the following step, use NEW mounting bolts or clean and apply Mopar(R) Stud & Bearing Mount Adhesive or
equivalent to the original mounting bolt threads before reuse.
3. Install the four bolts (8) securing the hub and bearing (5), support plate (2), and spacer (7) to the knuckle. Tighten the mounting bolts to 105 Nm
(77 ft. lbs.).
4. Insert the parking brake cable into its mounting hole in the brake support plate. Push the cable housing in until the retainer's fingers lock into place.
