Avenger V6-2.7L (2008)
6. With finger tips, seat the dust boot lip (1) into the boot groove in the caliper bore. Trace around the outside perimeter of the dust boot with a finger
tip making sure the lip is properly seated in the groove and not much air is trapped behind the boot.
7. Position one end of the boot snap-ring (1) inside the boot outer lip (2), then making a circular motion, walk the snap-ring around the boot lip,
completely installing and seating it.
8. Inspect whether the two ends of the boot snap-ring are not overlapping one another. If they are, push the snap ring and dust boot further into
groove removing any overlap of the snap-ring.
9. Install the caliper on the vehicle and bleed the brakes as necessary. See: Removal and Replacement/Disc Brake Caliper - Installation
Front
ASSEMBLY
NOTE: Always have clean hands when assembling a brake caliper.
NOTE: Always use fresh, clean brake fluid when assembling a brake caliper.
