Avenger V6-2.7L (2008)
9. Connect the wiring harness connector (1) to the brake fluid level switch (2).
10. Connect the negative (ground) cable on the battery.
11. Fill the master cylinder reservoir to the proper level. See: Brake Fluid/Service and Repair
WARNING: Be certain a firm brake pedal is achieved prior to attempting to operate the vehicle. If a firm brake pedal cannot be
achieved, bleed the brake hydraulic system and check for leaks. See: Brake Bleeding
12. Road test the vehicle to ensure proper operation of the brakes.
Master Cylinder - Without ABS
MASTER CYLINDER - WITHOUT ABS
NOTE: The proportioning valves are not identical and cannot be interchanged. The proportioning valve that threads into the primary port has
7/16 in.-24 threads in its outlet port. The proportioning valve that threads into the secondary port has 3/8 in.-24 threads in its outlet port.
1. If removed, install the proportioning valves in their master cylinder ports. Tighten the proportioning valves to 30 Nm (22 ft. lbs.).
NOTE: The master cylinder must be bled before installing it on the vehicle.
2. Bench bleed the master cylinder. See: Procedures
3. Wipe the face of the power brake booster clean where the master cylinder seal comes in contact when it's installed. Do not get any cleaner or
debris inside the booster.
