Avenger V6-2.7L (2008)
8. Remove the retaining clip (2) securing the power brake booster push rod (1) to the brake pedal. To do so, position a small screwdriver under the
center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3).
Remove and discard the clip. Do not reuse the clip.
9. Slide the booster push rod (1) off the brake pedal pin (3).
10. Remove the four nuts (4) attaching the power brake booster (3) to the dash panel.
11. Slide the power brake booster (3) forward until its mounting studs clear the dash panel, then remove it through the engine compartment.
