Avenger V6-2.7L (2008)
9. Connect the rear brake tubes (1) to the junction block (2). Tighten the tube nuts to 17 Nm (150 in. lbs.).
10. Install the master cylinder. See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and Replacement/Master Cylinder -
Installation
11. Install the powertrain control module (PCM). See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Powertrain Control Module - Installation
12. Connect the battery negative cable to its post on the battery.
13. Bleed the base brake system. See: Brake Bleeding
14. Road test the vehicle to ensure proper operation of the brakes.
