Avenger V6-2.7L (2008)
10. Remove crankshaft sprocket See: Timing Components/Timing Chain/Service and Repair/Timing Chain & Sprockets - Removal.
11. Remove oil pump See: Engine Lubrication/Oil Pump/Service and Repair/Removal and Replacement/Engine Oil Pump - Removal.
12. Remove crankshaft rear oil seal retainer See: Crankshaft Seal Retainer/Service and Repair/Crankshaft Rear Oil Seal Retainer - Removal.
13. Remove structural windage tray (1).
14. Turn crankshaft until connecting rod cap to be removed is accessible.
NOTE: Connecting rod bearing caps are not interchangeable and should be marked before removing to ensure correct reassembly.
CAUTION: DO NOT use a number stamp or a punch to mark connecting rods. Damage to connecting rod could occur.
15. Mark connecting rod bearing cap positions using a permanent ink marker or scribe tool.
16. Remove connecting rod bearing caps. Use care to prevent damage to the crankshaft bearing surfaces.
CAUTION: Care should be taken not to damage the fractured rod and cap joint face surfaces or damage to the engine may occur.
