Avenger V6-2.7L (2008)
Crankshaft Main Bearing: Specifications
MAIN BEARING CAPS
NOTE: Lubricate main bearing cap bolts with engine oil before installation.
The main bearing cap bolts must be tightened in the proper sequence. First the inner main cap bolts, secondly the windage tray bolts, and lastly the
main cap tie (horizontal) bolts.
-
Install the inside main bearing cap bolts and tighten to 20 Nm + 1/4 Turn (15 ft. lbs. + 1/4 Turn).
-
Measure crankshaft end play See: Crankshaft/Service and Repair/Procedures.
-
Install connecting rods and measure side clearance See: Connecting Rod Bearing/Service and Repair.
-
Install windage tray. Lubricate bolts with engine oil and tighten to 27 Nm + 1/4 Turn (20 ft. lbs. + 1/4 turn).
-
Install the main cap tie (horizontal) bolts and tighten to 28 Nm (250 in. lbs.).
STANDARD PROCEDURE - CRANKSHAFT MAIN BEARING FITTING
The grade marks for the cylinder block main bearing bore grade is located on the pan rail just below the left side engine mount bracket. These marks are
read left to right, corresponding to main bore 1, 2, 3, 4.
