Avenger V6-2.7L (2008)
Control Assembly: Service and Repair
A/C Heater Control - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Remove the console bezel (1) and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center
Console Bezel - Removal.
3. Remove the four screws (2) that secure the A/C-heater control (3) to the back of the console bezel and remove the control.
