Avenger V6-2.7L (2008)
11. Position the blend door actuator (2) onto the left side of the air distribution housing (3). If necessary, rotate the actuator slightly to align the splines
on the actuator output shaft with those in the blend door lever.
12. Install the screws (1) that secure the blend door actuator to the air distribution housing. Tighten the screws to 2 Nm (17 in. lbs.).
13. If equipped with the 2.0L diesel engine, install the electric positive temperature coefficient (PTC) heater unit into the air distribution housing (2) .
14. Install the heater core into the air distribution housing See: Heater Core/Service and Repair/Installation.
15. Install the air distribution housing onto the HVAC housing (1) See: Removal and Replacement/HVAC Housing - Installation.
16. Install the HVAC housing assembly See: Removal and Replacement/HVAC Housing - Installation.
Air Inlet Housing
HOUSING-AIR INLET
NOTE: LHD model shown in illustrations. RHD model similar.
