Avenger V6-2.7L (2008)
higher. The software release level is visible in the blue header at the top of the StarSCAN(R) screen.
NOTE:
The StarSCAN(R) diagnostic scan tool fully supports Internet connectivity. However, to take advantage of this feature you must first configure the
StarSCAN(R) for your dealership's network. Make sure the StarSCAN(R) is configured to the dealership's network before proceeding. For
instruction on setting up your StarSCAN(R) for the dealer's network refer to either:
"DealerCONNECT > Service > StarSCAN and StarMOBILE tools > Online Documentation", or refer to the StarSCAN(R) Quick Start
Networking Guide. The StarSCAN(R) Quick Start Networking Guide is also available on the website under the "Download Center".
1.
Install a battery charger and verify that the charging rate provides approximately 13.5 volts. Set the battery charger to continuous charge. Do not
allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is complete.
2. Connect the CH9410 StarSCAN(R) ethernet cable to the StarSCAN(R) and the dealer's network drop.
3.
Connect the CH9404 StarSCAN(R) vehicle cable to the StarSCAN(R) and the vehicle.
4.
Power ON the StarSCAN(R).
5.
Retrieve the old WCM part number. Using the StarSCAN(R) at the "Home" screen:
a.
Select "ECU View"
b.
Touch the screen to highlight the WCM in the list of modules.
c.
Select "More Options"
d.
Select "ECU Flash"
e.
Record the part number at the top of the "Flash" screen for later reference.
f.
Select "Browse for New File". Follow the on screen instructions.
g.
Select "Download to Scantool".
h.
Select "Close" after the download is complete, then select "Back".
i.
Highlight the listed calibration.
j.
Select "Update Controller". Follow on screen instructions.
k.
When the update is complete, select "OK".
l.
Verify the part number at the top of the "Flash" screen has updated to the new part number.
NOTE:
Due to the WCM programming procedure, a DTC may be set in other modules (PCM, TCM, BCM, MIC, RADIO, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All
Stored DTCs" if there are any DTCs shown on the list.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
