Avenger V6-2.7L (2008)
c. With the brake pedal in the fully released position, move the adjustment lever on the brake lamp switch from the 45° angled non-adjusted
position, clockwise as shown, until it is parallel with the wiring connector. The brake lamp switch is now properly adjusted to the vehicle.
3. Connect the wiring harness connector (4) to the switch (3).
4. If equipped, install the silencer pad below the steering column.
5. Reconnect the battery negative terminal.
6. Check the stop lamps to verify they are operating properly and not staying on when the pedal is in the released position.
7. Road test the vehicle to ensure proper operation of the brakes (including ABS) and speed control (if equipped).
