Avenger V6-2.7L (2008)
NOTE: Illustration shown with front fascia removed for clarity.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Procedures/Refrigerant System
Recovery.
3. Raise and support the vehicle.
4. Remove the A/C accumulator See: Heating and Air Conditioning/Accumulator HVAC/Service and Repair/Removal.
5. Reach up through the opening in the bottom of the front fascia located in the right front corner of the vehicle and remove the nut (3) that secures
the A/C liquid line (1) to the A/C condenser (2).
6. Disconnect the A/C liquid line from the A/C condenser and remove and discard the O-ring seal and gasket.
7. Install plugs in, or tape over the opened refrigerant line fittings and the condenser and accumulator ports.
8. Lower the vehicle.
9. Remove the three nuts (2) that secure the heat shield (3) to the three studs (1) located on the dash panel in the engine compartment and remove the
heat shield.