Avenger V6-2.7L (2008)
NOTE: It is only necessary to position the engine coolant reservoir and the power steering fluid reservoir out of the way. Draining of the
coolant and brake fluid is not required when servicing the washer bottle.
10. Remove the windshield washer reservoir See: Wiper and Washer Systems/Windshield Washer Reservoir/Service and Repair/Washer Reservoir -
Removal.
11. Remove the nut (1) that secures the refrigerant line retaining bracket (2) to the right front strut tower (5).
12. On RHD models, disengage the retainers that secure the power brake booster vacuum supply hose to the dash panel and position the vacuum line
out of the way.
13. Remove the bolt (3) that secures the A/C liquid and suction line assembly (4) to the A/C evaporator (6).
14. Disconnect the A/C liquid and suction line assembly from the A/C evaporator and remove and discard the dual-plane seals.
15. Install plugs in, or tape over the opened refrigerant line fittings and the evaporator ports.
16. Remove the A/C liquid and suction line assembly from the engine compartment.
Lower A/C Suction Line
17. Disconnect and isolate the negative battery cable.
18. Recover the refrigerant from the refrigerant systemSee: Heating and Air Conditioning/Service and Repair/Procedures/Refrigerant System
Recovery.
19. Raise and support the vehicle.
20. Remove the right front wheel See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Removal.
21. Remove the three push-pin retainers (1) and three screws (2) that secure the front portion of the right front wheelhouse splash shield (3) to body
(4) and position the front of the wheelhouse splash shield out of the way to gain access to the A/C accumulator.
