Avenger V6-2.7L (2008)
Catalytic Converter: Removal and Replacement
Front - 2.7L
FRONT - 2.7L
WARNING: The normal operating temperature of the exhaust system is very high. Therefore, never attempt to service any part of the exhaust
system until it is cooled. Special care should be taken when working near the catalytic converter. The temperature of the converter rises to a
high level after a short period of engine operation time.
1. Disconnect negative battery cable.
2. Disconnect upstream oxygen sensor connector.
3. Remove 3 converter attaching nuts that are visible from the engine compartment.
4. Raise vehicle on hoist.
5. Remove exhaust cross-under pipe See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Cross Pipe - Removal.
6. Remove remaining bolt attaching converter to exhaust manifold.
7. Remove catalytic converter.
8. Remove and discard gasket.
Rear - 2.7L
REAR - 2.7L
